Multi Purpose Pu Foam FA33
FEATURES
SHUODE FA PU FOAM is a one-component, economical type and good performance Polyurethane foam. It is fitted with a plastic adapter head for use with a foam application gun or a straw. The foam will expand and cure by moisture in the air. It is used for a wide range of building applications. It is very good for filling and sealing with excellent mounting capacities, high thermal and acoustical insulation. It is environmental friendly as it does not contains any CFC materials.
| Base | Polyurethane |
| Consistency | Stable Foam |
| Curing System | Moisture-cure |
| Tack-Free Time (min) | 8~15 |
| Drying Time | Dust-free after 20-25 min. |
| Cutting Time (hour) | 1 (+25℃) |
| 8~12 (-10℃) | |
| Yield (L) | 40 |
| Shrink | None |
| Post Expansion | None |
| Cellular Structure | 60~70% closed cells |
| Specific Gravity (kg/m³) | 16-18 |
| Temperature Resistance | -40℃~+80℃ |
| Application Temperature Range | -5℃~+35℃ |
| Color | Champagne |
| Fire Class (DIN 4102 ) | B3 |
| Insulation Factor (Mw/m.k) | <20 |
| Compressive Strength (kPa) | >160 |
| Tensile Strength (kPa) | >30 (10%) |
| Adhesive Strengh(kPa) | >115 |
| Water Absorption (ML) | 0.3~8(no epidermis) |
| <0.1(with epidermis) | |
- Application where fire retardant properties are required;
- Installing, fixing and insulating of door and window frames;
- Filling and sealing of gaps, joint, openings and cavities;
- Connecting of insulation materials and roof construction;
- Bonding and mounting;
- Insulating the electrical outlets and water pipes;
- Heat preservation, cold and sound insulation;
USE
- Remove the dust, greasy dirt on the surface before construction.
- Spray a little water on construction surface whenthe humidity is below 50 degrees, otherwise the heartburn or punch phenomenon will appear .
- The flow rate of the foam can be adjusted by the control panel.
- Shakethe container for 1 minute before using, connect material container with spray gun or spray pipe, the filler content is 1/2 of the gap.
- Use dedicated cleaning agent to clean the gun Surface drying time is about 5 minutes, and it can be cut after 30 minutes, after 1 hourthe foam will be cured and achieve stable in 3-5 hours.
- This product is not UV-proof, so it is suggested to be cut and coatedafter the foam curing (such as cement mortar, coatings, etc.)
- Construction when temperature is lower than +5℃, to ensure the material can be exhausted and increase the foam expansion, it should be heated by 40 ℃ to 50 ℃ warm water
Related products
Packging: 350g, 700g, 750g, 900g, 950g
Packging: 350g, 700g, 750g, 900g, 950g
Packging: 350g, 700g, 750g, 900g, 950g
Packging: 350g, 700g, 750g, 900g, 950g